Brilink NT split

The NT split is a standard NT1Q with an integrated ADSL splitter. Once the ADSL interface is enabled, every ISDN connection equipped with the NT split becomes ADSL capable on the subscriber side due to integration of the NT1Q and the ADSL splitter in one device.

To support the ADSL strategy of the network operators, subscriber-side changes are no longer necessary for upgrades from ISDN to ADSL if the NT split is used. This leads to considerable savings in logistics during the conversion.

Functionally, the NT split is fully compatible with an NT1Q and an ADSL splitter. The NT1Q and the splitter are optimally coordinated in the NT split, thereby providing advantages in terms of transmission characteristics.

The data transfer takes place via line code 2B1Q. The German Brilink NT split realizes the data transfer via line code 4B3T.

• Standard NT1Q with integrated ADSL splitter
• A single component with a compact design
• No changes required for ADSL activation on subscriber side
• Lower logistic costs
• Increased customer satisfaction

Interfaces

1. Uk0:
   - for connection to ISDN network
   - line code 2B1Q
   - transmission range (with noise) ≤ 4.2 km (0.4 mm)
2. ADSL:
   - for connection of an ADSL modem
3. S0:
   - for connection of up to 8 ISDN devices
4. Ttransmission range
   - short passive bus ≤ 220 m
   - point-to-point ≤ 1100 m

General

1. Weight: 0.45 kg
2. Dimensions (H x W x D): 35 x 145 x 110 mm
3. Maximum power consumption at Uk0:
   - normal mode 450 mW
   - restrictive mode 950 mW
4. Power supply to ISDN S0 interface (40V):
   - normal mode 4.5 W
   - restrictive mode 420 mW